Ottovac - The electric suction cup
Ottovac - The electric suction cup
This new tool completely removes the pump action that is traditionally needed to gain suction to the cup in addition, it also removes any mistrust on the actual vacuum suction the tool has on your glass because this new tool comes with the revolutionary automatic on / off sensor.
The automatic on / off sensor is built in the tool that tells the vacuum pump to engage to build suction, and to stop when it reaches sufficient vacuum, careful not to build too much suction and break or “pop" your glass. On the other side of the issue, in the event the tool begins to lose suction or “bleed” the tool will kick back in and regain suction, so you’ll always be in the safe zone for as long as you need it. When the vacuum in the base of the suction cup reaches -55 kPa, the pump will automatically stop after a three-second
delay.
When the vacuum level drops below -55 kPa, the pump will automatically restart, reaching the required pressure during operation. The tool is rated to safely hold up to 200kg/440lbs! and is powered by 4 AA batteries.
Applicable Surface TypePeak/valley heights less than 0.1” (3mm), arc less than 5°
Model/SKU | OTTOVAC-V1(OV-V1) |
---|---|
Battery | Alkaline AA 1.5 V (x4) |
Working voltage | 6 V |
Rated power | 6 W |
Working cycle | 1500 ON-OFF cycles of 10 seconds |
Service life | > 10000 times, > 800h |
Rated air flow | 4 l/min |
Maximum vacuum rate | -0.7 bar (-70 kPa) |
Maximum lifting capacity | 200 kg (440lbs) |
Dimensions | 200x200x90 mm |
Net weight (with battery) | 1.2 kg (2.6 lbs) |
Working temperature | 0-60°C (32-140°F) |